Pay in 4 interest-free payments of $24.74 Learn more
Ships within 48 hours · Estimated delivery Jul 31 - Aug 5
Supports 37" tires and up to a 4
steel with zinc coating
If you're setting up a whole suspension system
1-1/4"-12 right hand thread tube insert for 1-1/2" ID tubing (specifications below)
and the center pin hole is machined parallel to the opposite side so there's no side load on the center pin when you tighten the nut
Forged Driveshaft Yoke Kit with Pinion Seal and U-Bolts, 24 Spline, 1310, (PM3112-1003GK, N2-4-JK02) Supports 37" tires and upForged, 24 spline, 1310, U bolt style yoke for JK rear differentials with a new pinion seal and U bolts. This yoke takes a 1310 u joint (3. 2188" cap to cap wide, 1. 0625" cap diameter) and U bolts (NOT straps). WARNING: Some differentials use a crush sleeve to set the pinion bearing preload. Over tightening the pinion nut on a differential that has a crush sleeve can cause catastrophic failure of the differential. If you're not sure of what a crush
US$ 199.00
US$ 149.50
US$ 199.50
US$ 199.00
US$ 599.50
US$ 399.50
US$ 199.00
US$ 199.00
US$ 249.50
US$ 699.98
US$ 149.50
US$ 899.98
US$ 199.00
US$ 399.50
US$ 199.50
US$ 149.50